Hi,what do you want to compile? It's compiled, just use the .dtbo (copy it to your overlay folder, that's it)Thank you very much for the help.vc4-kms-dsi-generic-overlay.dts was added to the kernel recently.
As per the README you can configure it for a generic DSI panel that requires no initialisation sequence just using "dtoverlay=vc4-kms-dsi-generic,<properties>".
A DSI connector with no connected display is going to be bad news for EMC as you have several unterminated high speed signals. The display engages termination resistors at appropriate points as specified in the MIPI D-PHY specification.
To clarify, I only need to compile it without changing anything in the .dts right? Addresses such ' &dsi1 ' are not to be filled with register addresses.
Asking this cuz I had the following warning during compiling.
https://ibb.co/9n6dkzv
I was asking about dsi generic overlay mentioned by 6by9.
Thank you for your help also, I have tried your dtbo file however I could not observe DSI outputs in the oscilloscope.
Statistics: Posted by kdil26 — Thu Feb 29, 2024 12:56 pm
